Thanks for your response.
The cracks dont form on the side but all over the surface of the sheet and they dont tend to get deeper but remain even as i keep rolling. Im going to try annealing less often, particularly in the beginning
Not annealing at all? But what about when it work hardens?
I do keep the same side first in the rolling mill.
Thanks for the tips about the quenching and the small rolls. Will try it.
I dont have a photo at the moment but if/ when it cracks again i will take one and share
Hi,
I have been struggling with my sheet metal cracking while rolling for a long time now, and I can’t seem to find a solution that works for me. I have tried different annealing temperatures, rolling while reducing the pressure only slightly, quenching in water and alcohol.
Once I melt it, I...
I tried cleaning with abrasives and pickling.
Yes the gold does have a chance to melt sooner but I even tried sweating the solder onto the silver and it still forms these holes
Hey, I was making a piece which involved soldering 18k red gold wires to a Sterling silver dome. Most of them worked out fine, but for a couple of them the solder would burn through the silver and disappear rather than flow on top of it. I was using 18k red easy solder but layer tried with 18k...
Thanks for your post ralf.
I will try the abrasives first.
Nitric acid might be even harder to get in India if its not available in Germany so will have to check on that.
I do cover my piece with boric acid and alcohol but I think leaving it in the pickle results in cleaning that up plus...
Hi,
I made a piece in 18KY gold and the piece has got a greenish colour to it. I think it is caused by leaving it in the pickle (I use a citric acid pickle). From my understanding, it is caused by the copper leaching out of the surface of the metal into the solution. If I polish the surface...