Recent content by TallGary

  1. TallGary

    New Epson Eco Tank for transpaency transfers?

    The following HP black inks are pigment based and will transfer well. HP 60, 61, 62, 63, 64, 65, and 67 that I am aware of will all work. I recently set up a HP Deskjet 2755e with HP 67 ink and the transfer works well. Amazon has the printer at ~ $80 now marked down to ~ $50. Can be a bit of...
  2. TallGary

    allen screw

    Looks like it is 8-32 x 0.13 See the PDF in the link for the 901 handpiece parts list. https://grs.com/wp-content/uploads/2021/03/LIT-117_HP901_21.pdf
  3. TallGary

    Laser Printer drawing transfers

    Have you tried cleaning the brass plate? The ones I have used all seem to have a very light film of oil or something on them. Good luck!
  4. TallGary

    Question: Hoping to mine some ideas for a graver carrying case!

    I use the Dewalt MAXFIT 30 piece screwdriving set. Comes with a case. Take the bits out and snap the gravers in. Cost about $13 at Home Depot. https://www.homedepot.com/p/DEWALT-MAXFIT-Screwdriving-Set-with-Sleeve-30-Piece-DWAMF30/309474860
  5. TallGary

    Help, please: Grs engraving vice

    The instruction manual for the vise can be found on the GRS site https://grs.com/wp-content/uploads/2019/08/LIT-003-078_21.pdf Best regards, Gary
  6. TallGary

    Question: The problem of dividing section by a divider

    To make this easier... Print the PDF Select the template you need for your chosen number of segments. Place the ring on the template - centered for even spacing, off-center for graduated spacing. Mark the ring with your selected spacing. Hope this helps. Regards, Gary
  7. TallGary

    Question: The problem of dividing section by a divider

    Download the pdf files from the Tips Archive at the following link: -https://engraverscafe.com/threads/ring-divider-template.801/ You are not the only person to have issues with dividing a ring for engraving..... Best of luck with your project. Regards, Gary
  8. TallGary

    Experience with Transparency Film?

    On a very clean surface, - I wipe down with acetone -, coat it with one of the following and let dry. Easiest to find - Sharpie permanent marker in yellow or lime green Prismacolor marker in Blender or 40% Warm Grey - find at Hobby Lobby or Dick Blick Damar varnish - about 25% in 99% alcohol...
  9. TallGary

    Experience with Transparency Film?

    There is a very slight difference in the look and texture of the two sides of the Fixxon transparency film. The package is marked with the "Print Side", but I would recommend clipping the upper right corner if the film when taking it out of the package to help identify the correct side to print...
  10. TallGary

    Experience with Transparency Film?

    I have been getting a good transfer from Fixxon waterproof transparency film. $30/100 sheets. www.amazon.com/WaterProof-Transparency Regards, Gary
  11. TallGary

    Question: NGraver contact email

    At the bottom of the NgraveR home page click on the "NgraveR Co." link. Or failing that the address is Ngraver98@aol.com
  12. TallGary

    Announcement: A Great Engraver Honored.

    Congratulations Diane!
See more

Latest posts

Sponsors

Top