The Robert E. Lee Colt

Mike Dubber

Elite Cafe Member
Joined
Nov 10, 2006
Messages
424
Location
Evansville, IN
I've been working on this Robert E.Lee Colt for some time now and it's coming together in its final form. The engraving work is finished and it will go out tomorrow for bluing and assembly by John Powers.
These are shop photos of the gun loosely assembled to show some of the detail. The gun is an original Colt Black Powder Model 61 Navy. Both Lee and Grant carried 61 Navy Colt sidearms during the war - and they were both West Point graduates, as were a good number of the generals on both sides.
The various inlays depict some of the high points of General Lee's Career, including West Point, Arlington, and Washington & Lee University.
I iron inlaid the original inscription that was stamped down the left barrel (where the Confederate Battle Flag is inlaid) as well as iron to fill the screw holes on the right panel to make an area large enough for the Lee Chapel inlay. Lee and his family, as well as his horse Traveller, are buried at Washington & Lee.
This is a brief photo sampling of the Colt before it goes to finish...more later when it is all together.



 

Attachments

  • LeeF_02.jpg
    LeeF_02.jpg
    299.2 KB · Views: 63
Last edited:

Sam

Chief Administrator & Benevolent Dictator
Staff member
Joined
Nov 6, 2006
Messages
10,490
Location
Covington, Louisiana
The sparkle and depth of your cutting is fantastic, Mike! A beautiful job you did. Badass lettering as well! :beerchug:
 

monk

Moderator
Staff member
::::Pledge Member::::
Joined
Feb 11, 2007
Messages
10,857
Location
washington, pa
words sometimes just don't do justice to your design & execution skills. tyvm for showing
 
  • Like
Reactions: Sam

Mike Fennell

Elite Cafe Member
Joined
Apr 6, 2007
Messages
660
Location
Matteson, a south suburb of Chicago.
Mike, your research and attention to detail make every piece a masterpiece. Your engraving is so bold and clean, and your inlay work is amazing. I assume you will post more photos now that the gun is finished. I was honored to have the opportunity to have it in my hot little hands. I just wish I had more time to study it.
 

monk

Moderator
Staff member
::::Pledge Member::::
Joined
Feb 11, 2007
Messages
10,857
Location
washington, pa
not sure if it's possible- but your work always seems to be somewhat better each time you do a new piece. curious-- was the brass clean cutting ?
 

Mike Dubber

Elite Cafe Member
Joined
Nov 10, 2006
Messages
424
Location
Evansville, IN
Yes, the brass cut very clean, even though it was a bit brittle. I stripped the original silver off, then engraved, and then had the grip frame and trigger guard gold plated.
 

Attachments

  • RELKD_03.jpg
    RELKD_03.jpg
    78.3 KB · Views: 22

Sponsors

Top