Engraving block holding fixture

Joined
Dec 27, 2006
Messages
63
Location
Plainview NY
I just made this up for only the cost of a couple pennies, it helps hold a lot of things that otherwise I couldn’t use my block for.
 

Attachments

  • frame.jpg
    frame.jpg
    18.5 KB · Views: 1,061
  • fixture.jpg
    fixture.jpg
    7.9 KB · Views: 1,016
  • under.jpg
    under.jpg
    9.6 KB · Views: 1,040
Joined
Dec 27, 2006
Messages
63
Location
Plainview NY
Layout

I forgot to add the holes are 3/8” . You can make this out of what ever you want as big or small as you like; I was going to make it out of small plastic cutting boards (that stuff lasts forever) you can also put longer pegs in the holes to hold trays, big mugs ect... I have short L-brackets on the new one I made, I'm thinking of adding longer one's to stabilizes it a little better but it's not bad the way it is.

hope this helps.

God Bless
Ron Proulx
 

Attachments

  • top.jpg
    top.jpg
    26.3 KB · Views: 625
  • bottom.jpg
    bottom.jpg
    12.8 KB · Views: 633

Latest posts

Sponsors

Top