New Hermes IRX engravograph help needed

Joined
Dec 8, 2016
Messages
1
Thread starter #1
Hi,
Hoping someone here can help. We have an older New Hermes engravograph, Model IRX IV. It has been sitting for several years. We are unable to remove the cutter from the cutter spindle.
Any suggestions? Could it be "stuck" due to sitting idle? Contact with engravograph.com confirms they have limited replacement parts, & no cutter spindles, if we would need to replace.

Thanks for any help! If anyone has, or knows where to look, for replacement parts, info will be appreciated.
 

Ecomma

New Member
Joined
Jul 23, 2019
Messages
3
#2
My New Hermes GM has a left handed thread. It tried to take the cutter out, and realized I was turning it the wrong way. Also, I think cutters are available at a reasonable cost from Engravers Network. www.engraversnetwork.com
 
Top