Workholding (Jeremiah Wyatt)

Old Gunsmith

Elite Cafe Member
Joined
Aug 21, 2018
Messages
121
Location
SW Indiana
Nice presentation.
However, for this sort of work holding, I use the double sided tape that is available from woodworking suppliers such as Woodcraft. This stuff adheres to wood really well and is fairly easy to peel off. It comes in various widths like masking tape. The hot melt glue step is not required.
 

Old Gunsmith

Elite Cafe Member
Joined
Aug 21, 2018
Messages
121
Location
SW Indiana
There are several brands out there and all work about the same. The current brand I am using is XFasten Woodworking Tape. I got a deal on it. The main thing is to get a tape that you stick down and then remove a protective layer or film to expose the other adhesive surface. Really cheap tape sometimes does not have this and does not work as well.
 

Leland Davis

Elite Cafe Member
Joined
Nov 22, 2014
Messages
584
Location
Wells KS
I use hot glue for all kinds of work holding. Polishing hard to hold gun parts and engraving. If you glue to a long wood block and remove the centering device on your ball vise you can center anything under the scope.
I tried the double sided tape but bought cheap. It was a pain stuck to everything but where I wanted.
Leland
 

pkroyer

Member
::::Pledge Member::::
Joined
Aug 21, 2013
Messages
96
Location
Kansas City
I have used a wood turners tape I got from Woodcraft call Spectape, pressure sensitive tape. When used for woodturning, the problem is not that it does not hold, the problem is getting the pieces apart without damage. I have used it extensively in joining brass practice plates to steel plates to hold in the engraving vise. I usually put it in a bench vise to add pressure. I have had pretty good luck, but have noticed a little bit of lateral movement when pressing an edge with a fingernail or tool (looking under the scope). I do not seem to notice a problem when cutting, but at my skill level how could you tell. I just put some Xfasten tape into my wife's amazon cart. I also tried the green tape and hot melt glue yesterday, and it seemed to hold without any movement. My problem with hot melt tape is that it is not a matter of if I am going to get burned, it is when and how bad. Thanks to all who have commented
 

Leland Davis

Elite Cafe Member
Joined
Nov 22, 2014
Messages
584
Location
Wells KS
Yep it's best not try and wipe it off. that just spreads the burn. I have a large stack of different shaped blocks with glue on them just heat with a micro torch and press the part in less chance of getting burned.
 

Latest posts

Sponsors

FEGA
Top