monk's latest activity
-
Mmonk replied to the thread my frist shotgun engraving.looks to be great. a better foto would likely prove it's great. certainly great for yer first !
-
Mmonk replied to the thread Knife Engraving Question.as far back on the blade works for me. ymmv
-
Mmonk replied to the thread Do you see the face of the graver?.i f you reduce the size of the face, it should not be a problem. by properly shaping the graver, the face is reduced well below max. one...
-
Mmonk replied to the thread Information Requested for Revision of FEGA How-To Handbook.chemistry: the various acids, bases and and slew of "stuff" that makes work easier as well as better looking. also, electro etching...
-
Mmonk replied to the thread A few recent bits.uh, very nice i should say
-
Mmonk replied to the thread Saxophone engraving advice.i forgot to mention the brass is very thin. that's why one should put protective bags inside the instrument. it can prevent unwanted...
-
Mmonk replied to the thread Saxophone engraving advice.first order of bizzness: you must figure a way to safely cradle the sax. all the keys must be protected from damage. 2nd: go to yer...
-
Mmonk replied to the thread Latest efforts.byrnbucks got it right. nobody on this forum even became an amateur overnight, it takes time and practice.
-
Mmonk replied to the thread Question: Leica microscope s9d.are you certain that the objective is seated properly ? if the objective is off axis a bit, such could be the problem. is the prism...
-
MJK, only you can figure out what works for you. I sharpen on a 600 grit wheel after I grind the face I shut off the wheel and push the...
-
Mmonk replied to the thread Still looking at lasers.you're correct. cermark does just that. i u don't know where it'ss made now.se it for finished products. i've never used it as a layout...
-
Mmonk replied to the thread Just Starting Bright Cut and quick question.an xcellent vid. pack a lunch, it's long, but good
-
Mmonk replied to the thread Just Starting Bright Cut and quick question.also, when doing curves, esp tight ones, you turn the vise into the tool, not the other way around.
-
Mmonk replied to the thread why is there no information on laser machines for marking metal?.my,my, my--you're lucky.a tech was only at my place for one day !!
-
Mmonk replied to the thread Looking for feedback and constructive criticism.left of the grip is better.you still show disparity between the slide and frame.
Sponsors
