Recent content by Wolverine Gene

  1. W

    Sand blasted stainless steel

    Thanks for the reply's. I think we may be getting crossed up between a chip and a burr. The chip is what you pop out at the end of the cut. The burr is on both sides of the cut. When I finish my engraving I go over it with 2000 grit to remove the slight burrs on the sides of the cut. It...
  2. W

    Sand blasted stainless steel

    Hi:. I want to engrave a 1911 sand blasted slide. After it's engraved, what do you do with the burr left from the engraving, just leave it? Thanks...gene
  3. W

    Tisas stainless

    I'm not experienced enough for the correct feedback I'll get from a test cut in the slide. These pistols are hardened first, then machined to prevent warping. I will say that I'm a machinist and these guns are machined beautifully. What I did do was contact the importer and asked if I could...
  4. W

    Tisas stainless

    Thanks for the reply. I know my gun was not on the list, I checked already. I am looking for someone who done the slide for a professional opinion. Thanks...Gene
  5. W

    Tisas stainless

    Hi: Does anyone know if the stainless Tisas 1911 is a good pistol to engrave or is the Tisas stainless miserable and would not be a good choice. Thanks...Gene
See more

Latest posts

Sponsors

Top