Question: California air tools 6310 pressure issue!

[jml]

Hey Everyone!

im sure this was covered somewhere, but I couldn't find it :/... what should I adjust my pressure to for use with my Gravermach AT, and what additional fittings/connections should I use?

as you can tell I'm quote a novice with air assist. got a taste at GRSTC two weeks ago and I couldn't go back to the magnagraver.

thank you all in advance!

Justin

 

[dlilazteca]

http://www.grstools.com/resourcelibrary/manuals/

GunEngraver.com Guns, Knives & More

 

[jml]

thank you Carlos! would you recommend a specific pressure level? I'm scared to hurt the graverMach haha

 

[dlilazteca]

Dont have an at, but my output is at 40 to 60 psi from my compressor on average, but on your system it will depend on your handpiece fine tuning to get it to function at top level, you really need to sit down and read through the whole manual.

GunEngraver.com Guns, Knives & More

 

[jml]

thanks a million!