Chrome tourmaline ring

[Gemsetterchris]

This center stone posed abit of a challenge.
Having to do a fair bit of manipulation with a selection of burrs to get it sitting nicely at a good depth.
Small diamonds added to the end of the cross bars.
Should look abit better once polished.

 

[Eddi]

Nice one Chris! I really like it!
I have done a few similar ones.
Here is one of them: http://www.engraverscafe.com/showthread.php?6342-A-ring-I-made&p=62822#post62822

Eddi

 

[Gemsetterchris]

Nice one Chris! I really like it!
I have done a few similar ones.
Here is one of them: http://www.engraverscafe.com/showthread.php?6342-A-ring-I-made&p=62822#post62822

Eddi

I like yours alot Eddi, unfortunately the straight walls on this ring were too narrow for a quick channel setting
Took far longer than necessary to do.

 

[mgdesigns]

Are you going to do any hand engraving on the sides?

BTW: Very nice modern design - 14KW or Y?

 

[Gemsetterchris]

Are you going to do any hand engraving on the sides?

BTW: Very nice modern design - 14KW or Y?

It's 18Y.
Just a setting job sent over from the UK since I generally end up with work nobody likes to tackle
Not sure my scratching would do it any favours, but I'm considering playing around with some practice again.

 

[LVVP]

Looks very nice, thanks