riverratcoz
New Member
I am just starting out in engraving. I would like to ask if you could only have 5 engraver which one would it be.
Question: Engraver
- Thread starter riverratcoz
- Start date
mdengraver
~ Elite 1000 Member ~
FYI! You are the engraver.
The tools are the gravers.
The tools are the gravers.
Andrew Biggs
Moderator
Hi Riverratcoz
And welcome to the forum.
I'm not sure exactley what it is that you are asking............Perhaps if you rephased your question a bit then it could be better answered.
Cheers
Andrew
And welcome to the forum.
I'm not sure exactley what it is that you are asking............Perhaps if you rephased your question a bit then it could be better answered.
Cheers
Andrew
For me, squares, flats, rounds, liners, and custom made ones as needed. If i had to give up one, it would be the liners.
Marcus Hunt
~ Elite 1000 Member ~
Thinking about it, for 98% of my engraving I only use 5 tools:
115º
90º
80º for bulino
Scorper for lettering (aka 'flat' but made from square stock. I must admit to various widths though)
bent liner for background removal of English large scroll.
Like Monk says, if one had to go it'd be the liner
115º
90º
80º for bulino
Scorper for lettering (aka 'flat' but made from square stock. I must admit to various widths though)
bent liner for background removal of English large scroll.
Like Monk says, if one had to go it'd be the liner
Sponsors
