Work on spoon

[Akihiro NISHIZAWA]

I've engraved a stainless steel Fork.
It was very difficult because the surface is not flat.

 

[Marrinan]

Very Nice. Now you have to learn the wax transfer technique so you can move the design to the other sixty-four pieces in the severing set. There had special vices that would hold/clamp all the spoons on a rotating turn table so they could work them all of them at the same time. though usually just monograms but your wife will need the full monty. Fred

 

[monk]

very nice looking job you have done. i'll wager these will make the food taste better ! these appear to be silver. are they ?

 

[Akihiro NISHIZAWA]

Hi monk!
Thank you for your comment.

This fork is stainless steel.
I engraved with the Japanese ultra-Carbide.
It was very hard in stainless steel because it was the first time...

 

[Willem Parel]

Very nice scroll work, I like it very much, good cutting for a first time job.

 

[mdengraver]

In my opinion it's nice as a one of a kind piece. Something would be lost in making multiples of this.

 

[a.khaksari]

Nice job!

 

[Akihiro NISHIZAWA]

Thank you everyone.
I want to progress to practice more!