I was up at high pressure following the "Quick Start" section of the instructions, I've been running it much lower now, more like 40 - 50psi on the compressor and 20- 30psi on the graver end. Works great, I'm doing lots of practice cuts before I start anything more important. Thanks for your...
I was trying to run it at 60 psi and no, the piston was not moving. I posted this question on the Facebook group and they all recommended cleaning out the chamber and trying again. Once cleaned with denatured alcohol, it worked fine as long as I started with the graver pointed down. Problem...
Hi, everyone!
I recently received a Lindsay Bench Jewel Airgraver system as a present, it was purchased second-hand off of eBay along with the basic sharpening system. When I connect the graver compressor hookup and foot pedal to the air regulator, it doesn’t cause the piston to kick off, only...