Recent content by Sir Mac O Cheez

  1. Sir Mac O Cheez

    Hello All

    Thank you. I have a lot of automobiles I plan on doing.
  2. Sir Mac O Cheez

    Hello All

    I used to. I know I produce good stuff. I just know what it is going to take to become great. And I am still an amateur because I have produced a relatively small amount of engravings. And I refuse to give up until I reach that point.
  3. Sir Mac O Cheez

    Hello All

    Thank you. I still feel that I am an amateur. I have so much to learn still, and my artistic abilities (understanding shading and lighting) could use a bit of work.
  4. Sir Mac O Cheez

    Hello All

    I have a very healthy attitude towards many of my non-successes. I am not saying failure because I didn't fail; I just didn't succeed. I learned, and I did a hell of a job until it went poof, so I didn't fail. As for the fragile medium, it really isn't that bad. I have rarely broken any. Most of...
  5. Sir Mac O Cheez

    Hello All

    Right next to the broken Lion. It is a before and after picture. It is frustrating, but nothing I can do about it. Luckily it was being done just for fun.
  6. Sir Mac O Cheez

    Hello All

    Thank you. I loved the Corvette also until it went, poof. I was almost upset but just had to laugh. I have several old vehicles I plan on engraving. As for the details, anyone can do it with time and patience.
  7. Sir Mac O Cheez

    Probably engraving something super awesome.

    Probably engraving something super awesome.
  8. Sir Mac O Cheez

    Hello All

    I appreciate the kind words. There are only two completed with an NSK, which are the Smokey Joe's one and the Disney one. At least until I am done with my current project. Most of the detailed pieces were done with a MasterCarver Micro-Pro. The NSK is leagues better, so, I am excited to see what...
  9. Sir Mac O Cheez

    Hello All

    Hello all! My name is Thomas, and this thread is going to be a little about me and my Instagram link due to continually getting the warning that my file sizes were too large, regardless of how much I compressed them. I am a rotary tool user, and I am currently utilizing an NSK Espert 500. I...
See more

Latest posts

Sponsors

Top