I hand engraved a templet for this, 3 inch x 3 inch.The 3 traceings show the size range of my machine size 2 the largest and 7 smallest. And anywhere inbetween.
Hello Jim,
This is a great choice of design. If I got it right, the copied (traced) outcome is between one half and one seventh in size of the original engraving, but I'm uncertain if the three inches is the measurment of the material or the engraving on it. If it is the design, the max. size is about 38 mm, and the minimum about 11 mm high. The smaller versions could look very impressive. Will You add the details by hand engraving later? If this is a family related design, You might be able to supply a whole clan... I see You are looking for a reasonably priced end product. Please, don't go beyond using sterling silver. Your cost on such small pieces should be minscule.
Congratulations to your creativity and good luck to your endeavor. Please share with us the success story as well.
Greetings, Ivan