Cleaning annealed inlay metals

AllenClapp

Elite Cafe Member
Joined
Aug 7, 2019
Messages
376
Location
Raleigh, NC
When heated, some metals used for inlay will oxidize more than others. When you anneal inlay metal, do you clean off the oxide before inlaying it. If so, which of the following metals do you clean and how do you clean it?
Gold?
Fine Silver?
Copper?
Brass?
 

John B.

Lifetime Pledge Member
::::Pledge Member::::
Joined
Nov 9, 2006
Messages
3,950
Location
Los Angeles area, California.
Gold, silver I clean with Acetone before inlay.
Copper and brass I pull through an abrasive pad or 600 paper and then acetone.
It is a good idea to wipe down all inlay materials to remove any traces of hand acid.
Two dissimilar metal in contact with any acid are a set-up for future electrolyzes.
 

AllenClapp

Elite Cafe Member
Joined
Aug 7, 2019
Messages
376
Location
Raleigh, NC
Gold, silver I clean with Acetone before inlay.
Copper and brass I pull through an abrasive pad or 600 paper and then acetone.
It is a good idea to wipe down all inlay materials to remove any traces of hand acid.
Two dissimilar metal in contact with any acid are a set-up for future electrolyzes.
Great point about the hand acid; acetone will clean that off. I haven't been doing that on my practice inlays, but it would make sense for me to start. I usually don't wear latex gloves, so it sounds like, once I get the wire tacked in at the start, it would be appropriate to give the rest of the wire a gentle acetone swipe before hammering it in.
 

Latest posts

Sponsors

Top