mdengraver
~ Elite 1000 Member ~
Engraving Tools
Attachments
-
436aa91b179d314bd2f75a1ab3a69810.jpg
Engraving Tools
- Thread starter mdengraver
- Start date
AllenClapp
Elite Cafe Member
Mitch, from what source was this taken? Is a clearer copy available?
I must admit my ignorance about the "line" cut versus the "flat cut." They look the same in the illustration at this pixel level and I have never heard of that distinctive terminology difference.
I must admit my ignorance about the "line" cut versus the "flat cut." They look the same in the illustration at this pixel level and I have never heard of that distinctive terminology difference.
mdengraver
~ Elite 1000 Member ~
That's it!
Hello friends,
Could this be a page or poster from the Master Engraver Heinar Tamme?
If so, you could contact him via his website: Engraving Master Series - Heinar Tamme
Hope this helps.
B
Could this be a page or poster from the Master Engraver Heinar Tamme?
If so, you could contact him via his website: Engraving Master Series - Heinar Tamme
Hope this helps.
B
Chujybear
~ Elite 1000 Member ~
Line tool might be a liner.. florentine
Sponsors
