I know that this isn't 100% the place for my question but after reading AndrosCreations thread on balling up gold and hammering it in I'm hoping I can find some other suggestions here.
I am getting married next spring and I'm making my wedding ring. It will be turned out of titanium. I inherited my grandfathers wedding ring that is 14k gold. I want to re-purpose his ring for an inlay in the titanium. The inlay will be a simple straight groove that I will likely undercut on the sides. I've made a number of rings similar to this but using crushed stone for the inlay. On those rings the groove has been in the neighborhood of .030 deep.
My questions are,
What is my best bet as far as getting an already made gold ring into a groove?
Cut it into a strip? Little pieces? Stretch it out over the top of the ring and hammer it in?
Does heating the gold assist at all in the hammering process?
Would making the groove shallower reduce the material needed, be easier, or help any?
I'm open to any ideas.
Currently my last resort is to make the titanium ring in two pieces and press all three together but I'd prefer a one piece ring for the base.
Thanks!
I am getting married next spring and I'm making my wedding ring. It will be turned out of titanium. I inherited my grandfathers wedding ring that is 14k gold. I want to re-purpose his ring for an inlay in the titanium. The inlay will be a simple straight groove that I will likely undercut on the sides. I've made a number of rings similar to this but using crushed stone for the inlay. On those rings the groove has been in the neighborhood of .030 deep.
My questions are,
What is my best bet as far as getting an already made gold ring into a groove?
Cut it into a strip? Little pieces? Stretch it out over the top of the ring and hammer it in?
Does heating the gold assist at all in the hammering process?
Would making the groove shallower reduce the material needed, be easier, or help any?
I'm open to any ideas.
Currently my last resort is to make the titanium ring in two pieces and press all three together but I'd prefer a one piece ring for the base.
Thanks!