I use a square graver I convert to a micro flat by just grinding a very small flat at the tip. Is a very controllable tool that doesn't give much if any heel drag in the curvy bits.
Then I chisel the edges to make the undercut.
That's how I did the lettering on these barrels
So helpful to see how you pros do this step by step. Thank you so much Barry, Bert and Mike!
Gracias Barry por aportarnos esta información, es muy valiosa. Muchos de nosotros no tenemos la posibilidad de capacitarnos con grandes maestros como usted y este tema es maravilloso...
Saludos
Luis
Barry, is the barrel fixture you're using hand made or available for purchase, and if available, from whom?
Bill