BKJ
Elite Cafe Member
Hello All,
I am new and was looking at the Glensteel gravers. I noticed that there were V-Point gravers offered by GRS. These come in pre-ground points of 60, 75, 105, and 120 degrees.
My question is this;
Are they narrower so one doesn't have to grind them down to create a smaller face or are they 3/32nds all the way down?
The pictures seem to show them being narrower but it is hard to tell.
Any input would be appreciated.
Thanks,
Bruce the newbie!
I am new and was looking at the Glensteel gravers. I noticed that there were V-Point gravers offered by GRS. These come in pre-ground points of 60, 75, 105, and 120 degrees.
My question is this;
Are they narrower so one doesn't have to grind them down to create a smaller face or are they 3/32nds all the way down?
The pictures seem to show them being narrower but it is hard to tell.
Any input would be appreciated.
Thanks,
Bruce the newbie!