Bob Rearley
New Member
- Joined
- Aug 5, 2020
- Messages
- 3
Magna Graver II
Recently purchased a used Magna Graver II , however, it came with little info. I Find when I insert the graver into the collet that the top flat is not parallel with the top flat of the handle. Thus you have to twist the handle for the point to cut in the correct plane. Is there an adjustment for this? I have called the phone number listed on the website but there is no answer. I was told by a well known engraver that the owner passed away in June. Does anyone know how to reach the company anyone knI woulddoes anyone know greatly appreciate any suggestions on how I might contact a principle in the company.
Thanks, Bob
Recently purchased a used Magna Graver II , however, it came with little info. I Find when I insert the graver into the collet that the top flat is not parallel with the top flat of the handle. Thus you have to twist the handle for the point to cut in the correct plane. Is there an adjustment for this? I have called the phone number listed on the website but there is no answer. I was told by a well known engraver that the owner passed away in June. Does anyone know how to reach the company anyone knI woulddoes anyone know greatly appreciate any suggestions on how I might contact a principle in the company.
Thanks, Bob