Office desktop plaque

dimovengraving

Elite Cafe Member
Joined
Mar 3, 2009
Messages
526
Location
Sopot, Bulgaria
Hello,
recent work - Office desktop plaque:



- stainless steel
- hand engraving
- gold plating 24 K
- stand, walnut
- inscription on the other side
- french polish Used

Used :
:handpiece: Monarch, #901 and #720 handpieces
:chip: gravers : 120° , flat , stippling tool






This was :tiphat:
 

dimovengraving

Elite Cafe Member
Joined
Mar 3, 2009
Messages
526
Location
Sopot, Bulgaria
..... Did you also use the GRS-handpiece for the walnut inscription too?
Thanks for asking
For this I used a knife and round chisels R 1.5, R 2.0 mm. Handpush, for marking

And for cutting , air and Maestro Original handpiece
- Asymmetrical chisel - width of 2 mm, sharpening angle of cutting edge 24°
- Also a knife with a sharpening angle of cutting edge 16°



Thank you for comments monk and Adder :beerchug:
 

Latest posts

Sponsors

FEGA
Top