pmace
Elite Cafe Member
I literally stumbled on a product that seems to work to transfer laser (toner) images from a transparency sheet to a work piece. Clean the work and the image with isopropyl alcohol and apply a thin layer of Loctite 271 threadlocker to the image side of the film. Place the transparency image side down on the work and burnish out the air bubbles with a Q-tip. Let cure for 30-60 minutes and remove the film. The image stays on the work. Wipe with isopropyl alcohol to remove the uncured 271. If you get too much product on the film it gets a little rubbery when you cut through it.
I was using UV cure adhesive which works but this works better and is much cheaper. The Loctite 271 is the standard high strength red stuff in the hardware store.
I was using UV cure adhesive which works but this works better and is much cheaper. The Loctite 271 is the standard high strength red stuff in the hardware store.