In general can they be engraved? Thanks in advance:pencil:
Bama Elite Cafe Member Joined Dec 6, 2006 Messages 370 Location Alabama Dec 31, 2014 #1 In general can they be engraved? Thanks in advance
R rfattig Member Joined Mar 14, 2009 Messages 42 Dec 31, 2014 #2 Just did some lettering on a 6700, cut good but a little soft in places. This was just in the middle of the sides.
Just did some lettering on a 6700, cut good but a little soft in places. This was just in the middle of the sides.
Beathard ~ Elite 1000 Member ~ Joined Jun 22, 2011 Messages 1,476 Location Paige, TX Dec 31, 2014 #3 Cut them all the time. Can be a little hard near machined areas.
