Hi all,
I have the same dumb question as before. I was engraving this crappy little knife for practice, and i showed the pic just to show ya'll how I have it set up. Problem is, again, i keep breaking points. Is it because the side of the folding knife is flexing and vibrating. Do you guys usually wedge something in there to try to stiffen that up. Of course the knife was all of three dollars at Smokey Mountain Knife Works, and it's china's finest steel I'm sure. I guess it could lots of junk in it that I'm hitting. It seems soft as butter then I'm skidding all over the place. Sorry for asking everyone should know, but I'm kinda slow.
I have the same dumb question as before. I was engraving this crappy little knife for practice, and i showed the pic just to show ya'll how I have it set up. Problem is, again, i keep breaking points. Is it because the side of the folding knife is flexing and vibrating. Do you guys usually wedge something in there to try to stiffen that up. Of course the knife was all of three dollars at Smokey Mountain Knife Works, and it's china's finest steel I'm sure. I guess it could lots of junk in it that I'm hitting. It seems soft as butter then I'm skidding all over the place. Sorry for asking everyone should know, but I'm kinda slow.