dlilazteca
~ Elite 1000 Member ~
Hello everyone and thanks for looking.
Here is an idea I have.
Since I work with firearms and I use several chemicals, I usually have to poor the chemicals out into a bigger container so I can dip my parts into, then I have to poor them back into their original container since this takes up time I usually have to remove, for example, the blueing off the gun all at one time. I would prefer to remove lets say the cylinder bluing and then engrave it, french grey it and put it away then move on to the next piece.
Last gun that I did since I removed all the finish I had to place it in a bag spray it with wd40 to keep it from rusting.
Basically what I need is wide mouth container where I can dip my parts in and continue to work as efficiently as possible.
I found this item and was wondering if it would work or if you guys have solved this problem.
http://www.amazon.com/dp/B00B515DNC...TF8&colid=1M2CBOSHELORC&coliid=I1XFATGYOH31MS
Your advise is greatly appreciated.
Here is an idea I have.
Since I work with firearms and I use several chemicals, I usually have to poor the chemicals out into a bigger container so I can dip my parts into, then I have to poor them back into their original container since this takes up time I usually have to remove, for example, the blueing off the gun all at one time. I would prefer to remove lets say the cylinder bluing and then engrave it, french grey it and put it away then move on to the next piece.
Last gun that I did since I removed all the finish I had to place it in a bag spray it with wd40 to keep it from rusting.
Basically what I need is wide mouth container where I can dip my parts in and continue to work as efficiently as possible.
I found this item and was wondering if it would work or if you guys have solved this problem.
http://www.amazon.com/dp/B00B515DNC...TF8&colid=1M2CBOSHELORC&coliid=I1XFATGYOH31MS
Your advise is greatly appreciated.
Last edited: