1.) I rubbed RUBLEV LAMP BLACK into the cuts trying to fill them as evenly as possible.
2.) I then wiped off the surface trying to leave the black in the cuts.
3.) Next I pulled the design with clear tape.
4.) Applied transfer wax to the surface of the metal to transfer to.
5.) Positioned the tape and burnished the design.
As you can see, it picked up a lot of detail and is much easier to see than a typical transfer wax transfer.
Next I will try mirroring the design and see how that works.
2.) I then wiped off the surface trying to leave the black in the cuts.
3.) Next I pulled the design with clear tape.
4.) Applied transfer wax to the surface of the metal to transfer to.
5.) Positioned the tape and burnished the design.
As you can see, it picked up a lot of detail and is much easier to see than a typical transfer wax transfer.
Next I will try mirroring the design and see how that works.