Engrave-ability of new Python?

[mitch]

I didn’t see it mentioned in the archive list. Has anyone worked on a new one recently? Any comments besides the barrel cannot be removed? TIA!

 

[wowilson]

I did one. I thought it cut just fine. Pretty ungainly to hold in the vise, but doable.

 

[tdelewis]

The list of engrave-ability firearms was great when it was first put up. I don't think it has changed. It would be good if engravers would add ner guns to the list.

 

[FANCYGUN]

be careful of a thin spot just above the cylinder release. Easy to go right through to the other side. Dont ask how I know.

 

[JMiller]

be careful of a thin spot just above the cylinder release. Easy to go right through to the other side. Dont ask how I know.

Thanks for the tip, how did you fix it?... just curious, always like to know how to avoid or fix if possible.

 

[FANCYGUN]

fixed it with a spot of weld and then just stayed away from it.

 

[JMiller]

fixed it with a spot of weld and then just stayed away from it.

Thanks... will remember that!