Patrice Lemee
Member
My handpiece is overheating. It is already wrapped in tape but still uncomfortable after a while.
I found this thread:
http://www.engraverscafe.com/archive/index.php/t-15898.html?
So it seems I need to drill holes in the can but also adjust the valve.
The manual says:
E. The pressure outlet of the pump is provided with two special
Muffler/Filters. The first Muffler/Filter contains a filter element
for cleaning the pump exhaust air. The second Muffler/Filter
contains a Pressure Relief Valve set at the factory for 3 P.S.I.
DO NOT ADJUST THIS VALVE. Be sure the aluminum jars are
tight to prevent leakage.
Any idea if I can I do it myself?
I found this thread:
http://www.engraverscafe.com/archive/index.php/t-15898.html?
So it seems I need to drill holes in the can but also adjust the valve.
The manual says:
E. The pressure outlet of the pump is provided with two special
Muffler/Filters. The first Muffler/Filter contains a filter element
for cleaning the pump exhaust air. The second Muffler/Filter
contains a Pressure Relief Valve set at the factory for 3 P.S.I.
DO NOT ADJUST THIS VALVE. Be sure the aluminum jars are
tight to prevent leakage.
Any idea if I can I do it myself?