Compressor for GraverMax

[yoop24]

Dear experts Hello
Please tell if this (picture attached) compressor will fit GraverMax
Thanks, Joseph

 

[Tira]

Hello! I can't quite make out all the fine writing, but it would seem that it would work.

From the GRS website:
The GraverMach and GraverMax SC require
1.4 cfm at 45 psi minimum (40 liters per minute at 3 bar minimum)

 

[Sam]

Joseph: I ran a Gravermax on a very small airbrush diaphram compressor and it worked perfectly. I think Billzach did this too. I believe you're better off with a larger tank compressor, but what you posted should work.

 

[Billzach]

Sam
You got a good memory, i did use a small air brush compressor for about 5 years for my gravermate and gravermax and it worked fine, i have since changed over to a big compressor to run more tools at the same time.

 

[Dmitriy Pavlov]

Hi, Joseph.
I think, if you add at your compressor an air tank for a tires filling, as a receiver, it will be perfect. A 7 gall. tank in an any automotive store cost around $10.