Graver geometry for hand pushing

sam

Chief Administrator & Benevolent Dictator
Staff member
Joined
Nov 6, 2006
Messages
10,532
Location
Covington, Louisiana
View attachment 33009

View attachment 33010

Face:
Toolpost angle 35°
Rotation angle offset 10° to the left of 0.

Heel:
Rotation angle 40°
Graver is rocked from 0° to 15° to produce a large curved heel.

Offsetting the rotation angle moves the right cutting edge forward (or the left cutting edge back) so the graver favors a counter-clockwise (anti-clockwise) cutting direction.

If you're interested in hand pushing, then this is an easy graver to make.
 

Attachments

  • heel.jpg
    heel.jpg
    75.1 KB · Views: 533
  • face.jpg
    face.jpg
    44.4 KB · Views: 533

CarolP

New Member
Joined
Oct 31, 2015
Messages
2
New to sharpening on a PowerHone & 7 months new to hand pushing, I plan to make this graver tomorrow & try it out. Thank you for the settings. I have been using a 90, 105 & 120 with the GRS recommended geometry, and I do find slipping an issue with hand pushing the 120 in particular. I seem to gravitate to a steeper face angle & perhaps because I am new to engraving want to push too deep. Maybe this geometry will correct that tendency(?). idk... shall see.

Regards, CarolP
 

Latest posts

Sponsors

Top