nhcowboy1961
Elite Cafe Member
- Joined
- Feb 27, 2008
- Messages
- 174
Does anyone have some tips on how to cut the steel of my liner graver to make it shorter? As they come purchased they're too long to fit properly into the handpiece of my graver and I need to shorten it a bit and wind up with more pieces to use as well. I don't think my metal curring bandsaw is up to the task on that hard tool steel-Do I just snap them off in my vice with a sharp sideways glancing blow and grind to fit the handpiece (Monarch)?
Thanks a lot.
Paul
Thanks a lot.
Paul