Arnaud Van Tilburgh
~ Elite 1000 Member ~
Well yes this is also engraving. Transferred the design on a sheet of Ti, cutting with whatever graver, drilling the holes and instead of using a saw to pierce the negative space (between the circles), I used an onglette.
Ball bur and finishing it using a small hammer piece I first hammered on a diamond lap.
Yes easy to cast in silver, but one by one in Ti. So sure worth these nice Turquoises
Hope you like them.
arnaud
Ball bur and finishing it using a small hammer piece I first hammered on a diamond lap.
Yes easy to cast in silver, but one by one in Ti. So sure worth these nice Turquoises
Hope you like them.
arnaud