Bluetickhound
Elite Cafe Member
I just purchased an older GraverMach and several other tools on the buy sell page and am now set up to step away from hand pushing and join the modern world... I followed the GRS instructions for adjusting the hand piece and setting the bias so my question is this:
Are there exercises, tips, etc for acclimating myself into the pneumatic world? Sharpening the gravers isn't an issue as I have Sam's video for that, along with all the necessary equipment. The first (and so far, ONLY) graver I have tried has been a C-max 120 degree and if I'm not really careful (and sometimes even if I am!) it digs right in and I'm really not on the foot pedal much at all, at least I don't think I am anyway....
Like I said though, I just got the system set up for the first time today so I imagine I have to get a feel for it before getting too concerned... Any advise would be appreciated though!
Are there exercises, tips, etc for acclimating myself into the pneumatic world? Sharpening the gravers isn't an issue as I have Sam's video for that, along with all the necessary equipment. The first (and so far, ONLY) graver I have tried has been a C-max 120 degree and if I'm not really careful (and sometimes even if I am!) it digs right in and I'm really not on the foot pedal much at all, at least I don't think I am anyway....
Like I said though, I just got the system set up for the first time today so I imagine I have to get a feel for it before getting too concerned... Any advise would be appreciated though!