Search results

  1. Leland Davis

    Floor plate

    I recently was asked to do an engraving demonstration at a art festival. I didn't think people would want to just watch me cut so I went with transfer techniques. This is the piece I used to show wax transfer to try and maintain symmetry. This was the first time in a long time I sat down and...
  2. Leland Davis

    Selling your work

    Your work is very nice. J.J and monk nailed it. You have to get out there and be a self promoter. Self promoting is the hardest part for me anyway. Just a guess but I suspect a lot of us on here are very content in the solitude of engraving so getting out there is a struggle but it has to be done.
  3. Leland Davis

    What’s on your bench?

    Finished the 1911 antlered game slide. A 1911 doesn't have much room for an elk but I think it worked.
  4. Leland Davis

    Job I Just finished Winchester reproduction with Nimschke scroll

    Very nice JJ
  5. Leland Davis

    Drawing Pencil

    rounded
  6. Leland Davis

    Drawing Pencil

    Scribe
  7. Leland Davis

    Parallel Point Length

    JK, only you can figure out what works for you. I sharpen on a 600 grit wheel after I grind the face I shut off the wheel and push the heel about 3/4 of an inch on each side. It works for me but may not for you. I think you can get to hung up on exact geometry when consistency is more important...
  8. Leland Davis

    Question: Andu Bulino pen quality??

    Thank you JJ. I like it
  9. Leland Davis

    Question: Andu Bulino pen quality??

    JJ, how about a picture of your stippling tool
  10. Leland Davis

    Ballard single shot rifle

    JJ that looks great
  11. Leland Davis

    Another 61 Winchester

    Thank you monk.
  12. Leland Davis

    Here's a new one- Engraved Radiator

    It is cast but someone had to carve the casting blocks.
  13. Leland Davis

    Another 61 Winchester

    I recently finished this 61.
  14. Leland Davis

    What’s on your bench?

    A little more progress
  15. Leland Davis

    What’s on your bench?

    I have this Night Hawk 1911 the customer asked for a North American antlered game theme. Just getting started.
  16. Leland Davis

    custom gravers on the cheap

    I asked my dentist for some old burrs she gave me a pound of them, that's a lot of burrs. She was happy someone could use them.
  17. Leland Davis

    custom gravers on the cheap

    Search the forum John B micro graver
  18. Leland Davis

    custom gravers on the cheap

    Dental burrs can be used to make John B type gravers. I use them most of the time.
  19. Leland Davis

    Gold inlay question

    John and Sam thank you for your response. My goal is to keep the long graceful taper of the tail feathers. I tried again today using Sam's advice scribe for the teeth and gold wire. Much better results. I did grind a hybrid cutter a 90 degree v point with flat sides total width .010 with it I...
  20. Leland Davis

    Gold inlay question

    I am doing the fox and pheasant in raised gold. My question is what is the best way to prepare the tail feather tips for gold. I have been practicing with fine silver. When I get the fine tips ready to hold the silver securely they are a little thicker than I want. Any suggestions?

Latest posts

Sponsors

Engraving-Videos.com
Engraving-Videos.com
FEGA
Top