Kind people of forum,
I just finished an engraving design for a knife bolster. Please tell me what you think of it and how can I improve it.
At first I wanted to make it rather simple design, but I probably printed out the bolster contours too big, and well, you see what happened. Is it too messy, or... springy with all those thin stems all over the design?
Just in case I attached the 'victim' too, where the design will go.
Oh, and if you'd like to see a video how this knife was made, then it is available on Vimeo: http://www.vimeo.com/862212.
Viljo
I just finished an engraving design for a knife bolster. Please tell me what you think of it and how can I improve it.
At first I wanted to make it rather simple design, but I probably printed out the bolster contours too big, and well, you see what happened. Is it too messy, or... springy with all those thin stems all over the design?
Just in case I attached the 'victim' too, where the design will go.
Oh, and if you'd like to see a video how this knife was made, then it is available on Vimeo: http://www.vimeo.com/862212.
Viljo