Question about 901AT Handpiece temperature

alwayslearning2012

:::Pledge Member:::
::::Pledge Member::::
Joined
Aug 24, 2012
Messages
43
Location
Louisville, KY, USA
I was cutting on aluminum last night, (this is my first real cutting session since my bench got set up) and I noticed my hand piece was getting a bit warmer than I remember it being when I took my basic class in Emporia. Is this normal? I'm using a 6 gallon Rigid pancake compressor.

Thanks in advance.
 
Last edited:

T.G.III

:::Pledge Member:::
::::Pledge Member::::
Joined
Jul 25, 2009
Messages
345
Location
Oregon
The air compressor will build heat depending on the rate of cycling on and off.
 

Latest posts

Sponsors

Top