tiny

[papart1]

Just lazy I guess

 

[papart1]

I prety much have gathered the size of scrolls applied to knives, guns, rings etc, are much smaller than this drawing. Just application design is where I LACK big time.

 

[papart1]

if the diagnosis of scroll construction is based on uniform line curving and the recognition of elbows and flats these errors are all on the outside of the scroll. I am fixin to get into an argument here I think, if you fix your drawing or attempt to , like I did in many areas, along with erasing, the final exceptance of a scroll is based on the outside of it's construction? Yes Hence, by cutting on the outside next to the line, theory would dictate a true cut.

 

[sam]

These backbones are pretty good and would cut well.
As for the design, I don't think it's a good one with the two scrolls facing each other. But I applaud your efforts. This is how it's done, one scroll at a time. And we all have about 500 bad scrolls in us that we have to draw out.

 

[papart1]

So Mr. Sam, I appreciate your critic, never again will there be facing scrolls, I can see ............there would not be a place for them in any design.